Saltar al contenido principal

Projects

Portfolio of the finished and current projects.

(In Progress) Gasoline/Diesel control unit​

Based on Zynq SoC.

🎯 Project's objective​

The aim of the project is control algorithms exploration, especially in area of neural networks and combustion data analysis.

Current state:​

  • ✅ FPGA angle position tracker IP
  • ✅ Base algorithms (VE based) for port fuel injection
  • ✅ Base spark control

Common rail pressure sensor adapter​

A device that allows to use 5V rail pressure sensor in 3.3V based systems like EDC17 range of ECUs, commonly found in E9x series BMWs.

ARM based products​

Following projects were developed on KE1xF/S32K14x series processors. All the projects use standard software package based on FreeRTOS. This base software provides C++ high level interfaces for peripherals and commonly used automotive services, like UDS diagnostics.

Development board and MCU module​

Universal development board based of KE1xF/S32K14x series processors. Equipped with a bare minimum of automotive peripherals (SBD + CAN transceiver). Processor board based on M2 connector allows to easily exchange the MCU(a useful feature in current ICs shortages).

Standalone Valvetronic controller​

Standalone Valvetronic and DBW controller for BMW's B58 series engines. Controlled by CAN/PWM.

CAN GPS​

25Hz GPS receiver with configurable CAN stream.

J1850 VPW to CAN Adapter​

J1850 VPW to CAN bus bridge. J1850 VPW is found in early 2000's Chrystler and Jeep vehicles. Configurable message mapping.

E9x DAQ Module​

Standalone DAQ module. Dual thermocouple input, 8 Analog Inputs, 2 CAN bus(P-CAN and configurable stream), 2 Full H-Bridges. Has a feature of displaying any data from PCAN/Sensor using CARPLAY/ANDROID AUTO. Can be programmed with additional control logic.